Home / Electronics / Photocoupler with UVLO function for digitally controlled switching power supplies

Photocoupler with UVLO function for digitally controlled switching power supplies

Toshiba Electronics Europe announces a new high-speed IC-Photocoupler for MOSFET gate signal insulation.

The TLP2735 is Toshiba‘s first photocoupler to incorporate an under voltage lockout (UVLO) function with hysteresis.

UVLO reduces the photocouplers susceptibility to noise that is often generated in power supply cables, and can prevent malfunctions at switch on.



With an isolation voltage of min. 5kVrms between the input and output, as well as compliance with the IEC60747-5-5 photocoupler safety standard, the new TLP2735 is suitable for all applications that require high levels of insulation performance.

The operating power supply voltage in the output side covers the 9 to 20V range, ideally suited to MOSFET gate voltages.

The high power supply voltage means that the device can also be used for IPM input insulation.

The TLP2735 offers a short propagation delay of 100ns (max) and a data transfer rate of 10Mbps.

The device is housed in a low profile SO6L surface mount package with a max. height of 2.3mm, that provides creepage and clearance distances of min. 8mm, supporting reinforced insulation requirements.

In addition, with an operating temperature range of -40 to 125°C, the device is highly suited to rugged industrial applications.

Check Also

Self-adapting USB 2.0 signal conditioner IC saves power and simplifies system design

Diodes Incorporated announces the introduction of the PI5USB212, a USB 2.0 signal conditioner that operates …

Non-stop transmission via fieldbus 

Ifm electronic introduces Ethernet modules for field applications, the AL4xxx series. These decentralised DI modules …

Analysis of up to eight simultaneous signals, improving multi-signal analysis capabilities for engineers

Tektronix, Inc announces the release of its SignalVu Spectrum Analyzer Software, Version 5.4, for multi-channel …