Home / Electronics / Enhanced sounder driver enables Audio UI in smaller smart sensors and wearables

Enhanced sounder driver enables Audio UI in smaller smart sensors and wearables

Can be fitted into portable and wearable devices, such as IoT-enabled trackers, as well as enabling miniature smart sensors that monitor the environment, including security detectors and water, smoke, and CO2 alarms

Diodes Incorporated announces an enhanced version of its sounder driver for small and portable devices. It delivers higher performance at a lower voltage in a smaller package.

Miniature piezo and ceramic sounders are now used extensively in trackers, alarms, health monitors, security devices, and smart sensors as a form of audio user interface. 

The sounders’ small size allows them to be fitted into portable and wearable devices, such as IoT-enabled trackers, as well as enabling miniature smart sensors that monitor the environment, including security detectors and water, smoke, and CO2 alarms. 

The PAM8904E sounder driver is designed to meet the requirements of the smallest application operating from extremely low voltages.

The PAM8904E can support both single-ended and differential output modes with minimal external components. 

The device features a wide-input voltage supply range between 1.5V and 5.5V and a shutdown current consumption within 1µA. The sounder also accepts an input signal between 20Hz to 300kHz. 

Despite its small size, the PAM8904E integrates a charge-pump boost converter that operates in 1x, 2x, and 3x modes. As such, the PAM8904E is able to generate an output voltage up to 18V peak-to-peak from a 3V supply voltage or 27Vpp from a 4.5V supply.

The enhanced option can now drive a sounder load up to 47nF, which is significantly higher than the drive capability of competing devices. 

Many competing devices can typically only drive a load of 15nF and require a higher supply voltage. The PAM8904E also features thermal shutdown, overcurrent protection, and short-circuit protection as well as an automatic shutdown and wake function that can help maximise the operational lifetime of battery-powered devices.

The PAM8904EGPR is available in the W-QFN2020-12 Type A package, which measures 2.00mm × 2.00mm wide × 0.80mm high. Other packaging options include U-QFN3030-12 Type A (PAM8904EJPR) and U-QFN3030-16 (PAM8904EJER).

Check Also

IC obsolescence: custom ICs provide a solution to lifecycle challenges

With hundreds of thousands of electronic components reaching end-of-life each year, often with little or …

Maintenance tips to get the most from your resistor

From railways to renewable energy to marine applications and motor control, resistors are an essential …

High-side switch acts as diode controller with reverse polarity protection and current blocking function for safe power control in automotive systems

Toshiba introduces the TPD7110F, a diode controller designed to enable safe power control and flexible design …

This website stores cookies on your computer. These cookies are used to provide a more personalized experience and to track your whereabouts around our website in compliance with the European General Data Protection Regulation. If you decide to to opt-out of any future tracking, a cookie will be setup in your browser to remember this choice for one year.

Accept or Deny